Tilar
Active contributor
Joined: 17 Jan 2007
Posts: 6
|
 Posted: Wed Jan 17, 2007 9:07 pm Post subject: WD800JB-00ETA0 board bad? |
 |
|
I pulled this drive out of a working computer in order to install another drive just to check and see if it was working. When I reinstalled the original drive, it was dead. I feel sure that static more than likely killed the PCB.
I have a 60 gig drive that works fine. Is it possible to swap these boards and get the data from my dead drive? Here are the drive numbers:
Dead 80 gig:
MDL: WD800JB-00ETA0
DATE: 27 Apr 2003
DCM: HSBHCTJAH
Number on the PCB near the 40 pin connector: 2061-001189-190 E XS 1J03 0LQS 1 0006430 3346
Working 60 gig:
MDL: WD600JB-00ETA0
DATE: 02 MAY 2003
DCM: HSCHCVJAH
Number on the PCB: 2061-001189-190 E XS 1J03 294L 4 0006440 3446
1) What are my chances of this swap working long enough to get some of the data from my dead drive?
2) Can this board be used if I swap something from the dead board to the good board?
3) If these two will not swap, Does anyone have a PCB that might work? |
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
